Tuesday, 29 July 2014
Advanced search

Precision 'stubby' gold nanorod synthesis offers hope for biomedicine

Imaging technologies and cancer treatments could be improved with the development of a process to produce gold nanorods in bulk with precise dimensions.

Gold nanorods made by the North Carolina State University process are said to be suited to biomedical applications due to their optical properties.

‘This technique should facilitate the economical manufacture of large volumes of gold nanorods,’ said Dr Joseph Tracy, an associate professor of materials science and engineering at NC State and senior author of a paper on the work. ‘And that should be good news for both the science community and the biomedical research and development community.’

The NC State team started with an existing technique, in which gold nanorods are formed by mixing two chemical solutions together. However, the technique converts 30 per cent of the gold into nanorods with the remains dissolved in solution.

To convert the remaining 70 per cent of the gold into nanorods, the researchers added a continuous stream of ascorbic acid to the solution, while constantly stirring the mixture, which pulls the gold out of the solution and deposits it on the existing nanorods.

The researchers also found that the slower they added the ascorbic acid, the ‘stubbier’ the nanorods became, an important outcome as the optical properties of gold nanorods depend on their aspect ratio.

Long, thin gold nanorods absorb light at wavelengths greater than 800 nanometres (in the near infrared spectrum), while shorter, wider gold nanorods absorb light at wavelengths below 700 nanometres (red or dark red).

‘The ability to fine-tune these optical properties will likely be useful for the development of new biomedical applications,’ Tracy said in a statement.

The paper detailing the work, Large-Scale Synthesis of Gold Nanorods through Continuous Secondary Growth, is published online in Chemistry of Materials.

The work was supported by the US National Science Foundation and National Institutes for Health.

Have your say


My saved stories (Empty)

You have no saved stories

Save this article

Digital Edition

The Engineer July Digi Issue


London Mayor Boris Johnson is lobbying for a £10 additional charge for diesel cars to drive into Central London by 2020, and for road tax on diesel cars and all pre-2006 cars to be increased, to counter air pollution. What option most closely matches your opinion on this?

Previous Poll

Europe's largest tidal array in the Pentand Firth off Orkney will eventually generate up to 86MW of power. What will it take for tidal energy to make an appreciable contribution to the UK's energy needs?

Read and comment on the results here