Tuesday, 29 July 2014
masthead+quote+image
Advanced search

Sensors to operate in very high temperatures

Newcastle University is developing wireless sensors that can withstand the very high temperatures of hostile environments such as nuclear power plants.

Researchers at the university are working on radiation and gas detectors that can operate at temperatures of several hundred degrees using electronics made from silicon carbide (SiC).

The team has developed the necessary components and are now working to integrate them into a device about the size of an iPhone that could be used in a variety of locations such as power plants, aircraft engines and even volcanoes.

‘If someone sets off a bomb on the underground, for example, this will still sit on the wall and tell you what’s going on,’ said Dr Alton Horsfall, a senior lecturer at Newcastle’s School of Electrical, Electronic and Computer Engineering. ‘If a dirty bomb has gone off you want to know what’s happened before you send anyone in.’

The university’s sensors can detect a variety of radiation types and gases including hydrogen sulphide and sulphur dioxide in concentrations of tens of parts per million at temperatures of 200-300°C.

SiC is used for the electronic components rather than silicon because it continues to operate at much higher temperatures. ‘Silicon’s a wonderful material to about 175°C and then it goes horribly wrong whereas silicon carbide runs to around 600°C on a practical level,’ said Horsfall.

The increased temperature resistance is due to the much stronger bonds between the silicon and carbon atoms, which also require more energy to release electrons for electrical conduction.

But this also makes it more difficult to manufacture into components. Silicon carbide wafers are also smaller and more expensive than ones made from silicon, although the cost is falling.

Newcastle’s success so far has been in developing the necessary components for the sensors. ‘You can’t use batteries very well so we’ve got energy-harvesting technology,’ said Horsfall. ‘We can build power management with the ability to boost voltages on a self-starting system.

‘We can then fasten these onto a comms board that uses our technologies as well. We can build capacitors that get to ridiculous temperatures - we’ve got one to 650°C. We can also do optoelectronic communication, building photodiodes and LEDs that run at around 1Ghz and 300°C.’

The initial work was funded by the EPSRC with contributions from the Technology Strategy Board (TSB) and other organisations. Newcastle University is now looking for funding to produce a prototype device and develop it for a specific application.


Readers' comments (2)

  • Please can you explain, the energy harvesting platform that you are using ?

    Jon.

    Unsuitable or offensive? Report this comment

  • Currently, we can use UV solar cells and piezoelectrics. Development is underway to use thermionic devices as an alternative, but this is probably a couple of years (or so)

    Alton

    Unsuitable or offensive? Report this comment

Have your say

Mandatory
Mandatory
Mandatory
Mandatory

My saved stories (Empty)

You have no saved stories

Save this article

Digital Edition

The Engineer July Digi Issue

Poll

London Mayor Boris Johnson is lobbying for a £10 additional charge for diesel cars to drive into Central London by 2020, and for road tax on diesel cars and all pre-2006 cars to be increased, to counter air pollution. What option most closely matches your opinion on this?

Previous Poll

Europe's largest tidal array in the Pentand Firth off Orkney will eventually generate up to 86MW of power. What will it take for tidal energy to make an appreciable contribution to the UK's energy needs?

Read and comment on the results here