Carbon nanotubes go with the flow

Researchers in the US have discovered that adding carbon nanotubes to a common commercial polymer leads to dramatic changes in how the molten polymer flows.

Researchers at the US National Institute of Standards and Technology (NIST) have discovered that the addition of carbon nanotubes to a common commercial polymer, polypropylene, leads to dramatic changes in how the molten polymer flows.

This process is said to eliminate a widespread manufacturing headache known as “die-swell” in which polymers swell in undesirable directions when passing through the exit port of an extruder, a machine for producing more or less continuous lengths of plastic sections.

Researchers have been adding small amounts of nanotubes to polypropylene in the hope of dramatically enhancing the material’s strength and other properties.

Once realised, this enhanced polymer could be processed at high speed through extruders for use in manufacturing.

NIST materials scientists were concerned that because nanotubes make the polypropylene rubbery, the material would be difficult to process or its enhanced properties would be lost.

The researchers found that the opposite proved true. When sheared (forced) between two plates, the polymer normally separates the plates. However, when nanotubes are added, the plates are pulled together.

The scientists discovered that this “pulling-together” completely alleviated die-swell. Industry currently uses various time-consuming trial-and-error solutions to deal with the problem.

NIST says eliminating die-swell should help manufacturers improve their time-to-market by simplifying their die design processes and enabling the controlled manufacture of smaller components.