A new heat-based technique for counting and measuring the size of microscopic particles has been developed in the US.
The technique, developed at North Carolina State University, the University of North Carolina at Chapel Hill and Marquette University, is claimed to be less expensive than light-based techniques and can be used on a wider array of materials than electricity-based methods.
’We launched this study purely out of curiosity, but it’s developed into a technique that has significant advantages over existing methods for counting and measuring the size of microscopic objects,’ said Dr. Glenn Walker, senior author of a paper on the work and an associate professor in the joint biomedical engineering program at NC State and UNC-Chapel Hill.
Particle counters are used in a wide variety of industries; physicians use them to count and identify blood and cancer cells while ink manufacturers use them to ensure consistent toner quality. According to NCSU, the new thermal technique could also lead to new applications.
The researchers built a device in which an extremely narrow plastic tube rests on a silicon substrate. A wire is connected to a single point beneath the tube and an extremely small current is run through the wire, both generating heat that radiates into the tube and measuring the temperature of the tube and its contents.
When a solution containing microscopic particles is injected into the tube it flows past the wire and the heated area. When the particles pass through this thermal zone they alter the electrical resistance of the wire because the thermal conductivity of a particle will either increase or decrease the temperature in that part of the tube, causing the electrical resistance to go up or down.
Since the researchers know the flow rate of the solution through the tube, they can measure the length of time that the electrical resistance was changed and calculate the size of the objects suspended in the solution.
‘So far, we’ve tested this method effectively with objects in the 200 micron to 90 micron range – at the larger end of the spectrum commonly measured by commercial particle counters,’ Walker said in a statement. ‘But in theory we’ll be able to get down to the 10 micron range and measure individual cells. We’re working on that now.’
The researchers are also exploring ways to use the technique to detect metal particles resulting from machine wear in mechanical devices.
‘There are three advantages to our technique,’ Walker said. ‘It’s simple, it’s inexpensive, and it can monitor any kind of particle. Flow cytometry – which uses light – is both expensive and complex, while Coulter counters – which use electricity – only work on objects that don’t conduct electricity but are suspended in a solution that is conductive.’
The paper, A Microfluidic Device for Thermal Particle Detection, was published online March 11 in Microfluidics and Nanofluidics.